[. . . ] • Attention should be drawn to the environmental aspects of battery disposal. • Do not install near any heat sources such as radiators, heat registers, stoves or other apparatuses (including amplifiers) that produce heat. [. . . ] This will prolong the life of your unit, help protect your device from static electricity and prevent potential damage. 2 jbl On stage 200iD USER GUIDE FCC STATEMENT AND WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient the receiving antenna. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Any special accessories needed for compliance must be specified in the instruction manual. MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT UNDER FCC RULES. www. jbl. com 3 Unpacking your jbl On stage™* 200iD IR remote MENU JBL On Stage 200ID Adapters for iPod/iPhone Power supply Audio cable Quick setup instructions • Plug the barrel end of the power supply cord into the power jack and plug the other end into the wall. • Next, push the power switch; a green LED will light up, indicating that the unit is powered. [. . . ] iPod et iTunes sont des marques commerciales de Apple Inc. , déposées aux États-Unis et dans d’autres pays. « Made for iPod » signifie qu’un accessoire électronique a été conçu pour ce connecter spécifiquement à l’iPod et que sa conformité aux normes de performances Apple a été certifiée par son constructeur. [. . . ]